Installation Guide

WALL
JAMB
NYLON
SPACER
#8 x 2” TRUSS
HEAD SCREW
Replace one wall jamb [B] and attach to the
wall with a #8 x 2” truss head screw [D] inserted
through the center hole. Slip a nylon spacer [E] over a
#8 x 2” truss head screw and install in the top hole
of the wall jamb. Repeat for the bottom jamb. Check
jamb for plumb and tighten screws.
NOTE: Do not over-tighten the jamb screws.
4
This bath enclosure is equipped with safety tee-
lock wall ja mbs. W he n installed properly, the header is
permanently loc ked to the wall jambs and cannot be
accidentally dislodged.
Measure the wall-to-wall opening at the top of the wall
jambs [B] and cut the header [F] 1/16” short of this
dimension. Check the header for fit.
Slide the safety tee-lock o f the unmounted wall jamb
into the header. The contoured surface of the header
goes to the e xterior of the unit.
Holding the header at an angle, engage the e nd onto the
mounted wal
l jamb. Pivot t he header into place, then
slide the loose wall jamb to the wall and press into
position on the tub track. Attach to the wall per
instructions in Step #4.
5
Obscure glass lites [G] should be installed with
the rough surface of the glass to the exterior of the unit.
Etched glass panels should be installed with the
patterned surface to the outside. Note that the hanger
brackets [H] are mounted in opposite directions to
create an interior and exterior door panel.
6
HEADER
WALL
JAMB
ROIRETXE
#8 x 2” TRUSS
HEAD SCREW
ROIRETNI
LENAP
HANGER
BRACKETS
ROLLER
BEARING
HEADER
GLASS
PANEL
ROIRETXE
LENAP
QCI5022 REV.2
Certified 12/15/16