Installation Guide

7
Before installing the door panels, the proper
orientation should be determined. For maximum water -
proofing, the interior panel should always be positioned
closest to the shower head, as shown in this illustration.
8
Slide one of the clear plastic discs [J], then
a glass hole sleeve [K] onto the back plate [I]. Push
the assembly through the hole in the glass panel,
so that the glass hole sleeve is flush with the other
side of the panel. Slide the other clear plastic disc
onto the protruding end of the back plate, and then
slide on the front plate [L]. Repeat this for the second
hole on the panel. While holding the towel bar [N] in
place, and screw the back plates into the towel bar.
NOTE: Outer panel has towel bar facing Out.
Inner panel has towel bar facing In.
N
L
J
I
J
K
Lift the interior g lass panel into position with
the rollers engaging the groove in the header [ F ].
Repeat for the exterior panel. If panels are not parallel
to their respective wall jambs, remove and adjust the
rollers up or down in their slots to compensate.
9
0
EXTERIOR
HEADER
INTERIOR
PANEL
EXTERIOR
PANEL
TUB
TRACK
QCI5022 REV.2
Certified 12/15/16