Installation Guide

MOLDED
BUMPER
WALL
JAMB
SCREW &
SPACER
INSERT
TUB
TRACK
GLAZED
PANELS
CENTER
GUIDE
INTERIOR
(2) #6 X 3/8 “
PAN HEAD
SCREW
Locat e the nylon bottom guide [ S ] in the
middle of the tub track [ A ] with the glass panels in the
position shown. With a 7/64” bit, drill two holes into
the V - groove through the mounting holes in the guide.
Install the bottom guide with two #6 x 3/8” pan head
s crews [ T ] thru the drilled holes as shown.
10
Slide the stainless steel bumper inserts [ U ] into
the four soft vinyl jamb bumpers [ V ]. Align the slots in
the bumpers with the glass panels and snap the bumpers
downward over the top and bottom wall jam b screws
[ D ] with the spacers [ E ].
11
CAULK
CAU
WALL
JAMB
TUB
TRACK
Neatly caulk each end of the tub track [ A ]
where it meets the wall jambs [ B ] and the interior edge
of the wall jambs as shown. Run a bead of caulking
along the interior edge of the tub track.
NOTE: The caulking should be allowed to cure for
twenty - four hours before using your new bath
enclosure.
12
QCI5022 REV.2
Certified 12/15/16