Installation Guide

CURVED TOWEL BAR SUPPLEMENT
Slide one of the clear plastic discs [J], then
a glass hole sleeve [K] onto the back plate [I]. Push
the assembly through the hole in the glass panel,
so that the glass hole sleeve is flush with the other
side of the panel. Slide the other clear plastic disc
onto the protruding end of the back plate, and then
slide on the front plate [L]. Repeat this for the second
hole on the panel. While holding the towel bar [N] in
place, and screw the back plates into the towel bar.
NOTE: Outer panel has towel bar facing Out.
Inner panel has towel bar facing In.
I. 4 SC46-A Back Plates
J. 8 SC46-B Clear Plastic Discs
K. 4 SC46-C Glass Hole Sleeves
L. 2 SC46-18/SC46-24 Towel Bars
M. 4 SCR46 Screws
X. 1 SC46-D Allen Wrench
X
I
J
L
J
K
M
QCI5022 REV.2
Certified 12/15/16