Installation & Assembly_1

QCI0028 Rev. 2 Page 7 of 10 Certified 06/05/09

STRIKE

PLATE

STRIKE PLATE

VINYL

LATCH

8 Slide the door latch [I] onto the strike side of

the door panel. Close the door and slide the latch up

and down until the magnet and strike plate are aligned.

Use a pencil and/or masking tape to mark the location

of the latch on the door.

Fold the vinyl material [over the strike edge of the

door and carefully drive the latch onto the door

panel using a rubber or plastic mallet.

Close the door and check for proper operation of the

latch and magnet. (If adjustment is needed, use a rubber

or plastic mallet and a wood block and lightly tap into

place). Trim the excess vinyl off with a utility knife.

NOTE: NEVER hit the door latch with a

metal hammer!!

9 See supplement instruction sheets for installation

of either the double-sided “C” pull handle or the

“C” pull handle/towel bar combo.

10 NOTE: The clear bottom sweep [C] is

notched on both ends. For installation, determine

if the door is hinge right or hinge left.

DOOR

GLASS