Installation & Assembly_1

QCI0028 Rev. 2 Page 8 of 10 Certified 06/05/09
11 Align the clear bottom sweep to the
bottom of the door with the deflector lip on the
inside of the shower door. Mark the strike side
of the bottom sweep even with the strike edge
of the door.
Cut the sweep leaving the notched part under
the metal rail.
12 Place the sweep onto the bottom of the door.
Stand inside the shower, close the door and mark the
deflector part of the sweep at the inside edge of the
strike jamb.
Open the door and remove the sweep. Notch the
inside portion of the sweep so the door glass will
close tightly to the strike jamb vinyl.
Place the sweep back on the door and check for
clearance.
INTERIOR
SILICONE
12 Carefully silicone the seam between the walls
and the wall jambs as well as the curb and threshold
on the inside of the shower.
NOTE: Silicone on the exterior seam is optional.
DO NOT USE the shower until the silicone is
completely cured. Check the tube of silicone
for the manufacturer recommended cure time.
(typically 24 - 48 hours)