Installation Guide

Insert the two nylon pivot bushings [Y] into
the pivot holes in the head and curb fillers [P].
Lift the door panel [L] and insert the top pivot pin into
the pivot bushing in the header filler. Hold the door
vertical and insert the bottom pivot pin into the pivot
bushing in the curb filler. It may be necessary to
remove the header retaining screws and raise the header
slightly to install the door.
When the door has been set into place, snap the security
washer [AA] over the top pivot pin to hold the upper
pivot bushing in place and prevent accidental
dislodging of the door.
13
The drip rail [R] is pre-cut from the factory.
Clean the bottom rail and the drip rail thoroughly with
rubbing alcohol to ensure proper adhesion. Unroll the
double stick tape [V] and carefully apply it to the back
of the drip rail (do not peel the tape backing yet).
Insert the tapered drip vinyl [T] into the drip rail.
Position the drip rail flush with the bottom and pivot
side of the door panel [L], then raise the strike side
until the bottom edge of the drip vinyl is parallel to the
curb [A]. Mark the location of each end of the drip rail.
14
Adjust the drip vinyl [T] by sliding it left or
right until it almost touches the curb. Trim the vinyl
(flush with the pivot end and notch 1/4” longer than the
drip rail as shown on the strike end).
The drip plug [S] is supplied with a left and right hand
plug together. Break the right and left drip plug apart
and insert the appropriate plug into the high (strike)
side of the drip rail. Discard the unused drip plug. Peel
off the tape backing and carefully press the drip rail [R]
to the door in the marked position.
NOTE: Cleaners with alcohol content can dissolve
the adhesive that attaches the drip rail. To prevent
this possibility, place a small bead of clear sealant at
the top of the drip rail where it is attached to the
bottom rail.
15
HEADER
SAFETY
WASHER
DOOR
PANEL
NYLON
SPACER
SNAP-IN
FILLER
PIVOT
BUSHING
CURB
PIVOT
SIDE
11/16”
STRIKE
SIDE
TAPE
DRIP
RAIL
DRIP
VINYL
BOTTOM
RAIL
(ALIGN)
11/16”
BREAK
APART
DRIP RAIL
DRIP
PLUG
DRIP
VINYL
TAPERED
DRIP VINYL
1/4”
1/16”
QCI0012 REV. 1 Page 8 of 9 Certified 07/06/05