the INFINITY BIFOLD SemiFrameless Bifold Shower Door INFH11A BECAUSE THE SHOWER IS EVERYTHING www. Bas coS h o w e rD o o r. c o m | 8 0 0 . 4 5 .
Tools: To install your New Shower Enclosure, you may need the following: · Pencil · Drill · Hack Saw · Low Tack Tape · 1/8” & 3/16” Drill Bit · Caulk Gun · Tape Measure · Center Punch · Clear Silicone Caulk · 4’ & 6’ Levels · Files · Suction Cups · Utility Knife · #2 Phillips Screwdriver Safety Notes: · This unit is best installed by two people. · Handle the glass panels carefully and protect the edges.
LEFT OR RIGHT INSTALLATION LEFT HINGE INSTALLATION RIGHT HINGE INSTALLATION The bi-fold shower door can be installed to have the fixed hinge on either the left or the right when viewed from the outside. These installation instructions depict a hinge left installation. Hinge side selection does not impact water proofing. Instead, hinge side is often determined because of obstructions. This door opens into the shower.
BOM LETTER A A1 A2 A3 A4 A5 A6 B C D E F G H I J K L M N O P Q R S T U V W X Y ## ## ## ## A QCI-5305 REV 2 DESCRIPTION QTY PART NUMBER DOOR PANEL ASSEMBLY 1 SP1411 GLASS 2 RAIL 4 SC558 GLAZING VINYL 4 SCV57 CENTER HINGE 2 SC8220 NUT BLOCK 4 SC4261 8-32X1/2 PH FH SCREW 12 SCR73SV HEADER/CURB 2 SC715 WALL JAMB 2 SC713 ADJUSTABLE JAMB 2 SC714 BULB VINYL 1 SCV927T2 PARTS PACK 1 SC1411PP PIVOT BUSHING 2 SC4160 3/16" SPACER 2 SC4016 BLACK ROLLER 2 SC4357 SQUARE HEAD SCREW 2 SC5080 PIVOT BLOCK 2 SC4252 PLASTIC
L/N B H X A6 G F V M/O I P J A4 S D Y C W K A5 A2 T U Q R A1 A T E C F D J G B S I AS VIEWED FROM INSIDE OF UNIT QCI-5305 REV 2 5 CERTIFIED 03/01/2019
1 2 QCI-5305 REV 2 6 CERTIFIED 03/01/2019
3 Lightly mark on the mounting flange of each wall jamb at the positions shown. This will be where the installation hole is drilled. Pro-Tip: If there are nearby grout lines (within 2” above or below) but not at the locations marked, mark the closest grout line on the wall jamb. Drilling is usually easiest here.
5 6 Drill holes for mounting the door as described on the next page QCI-5305 REV 2 8 CERTIFIED 03/01/2019
If the fiberglass walls will not hold the screw, use the instructions found at the bottom of the page for installing on stone walls without blocking The finished wall thickness may require the customer to supply their own screws. Screws are required to seat into the blocking 1” minimum.
7 Most of the assembly of this unit will take place on the floor with the outside of the unit facing the floor. Please take precautions to prevent harm to the unit for work surface during assembly.
9 10 QCI-5305 REV 2 11 CERTIFIED 03/01/2019
11 12 QCI-5305 REV 2 12 CERTIFIED 03/01/2019
14 QCI-5305 REV 2 13 CERTIFIED 03/01/2019
15 16 QCI-5305 REV 2 14 CERTIFIED 03/01/2019
17 18 QCI-5305 REV 2 15 CERTIFIED 03/01/2019
19 20 Pro-Tip! If the rollers pop off of the track during normal operation, stack additional roller pivot bearings to increase the load on the rollers. The Parts Pack includes pieces to be used for both left and right hinged applications. Only 1 set of left or right parts will be requried for your installation.
21 22 Slide the Wall Jambs into place with the mounting flange facing up. They will be on the inside of the shower once the unit is stood up.
23 24 With a helper, stand the unit up on the floor. Use masking tape to hold the glass closed while the unit is lifted into place. Attach the tape to the top of the glass on the inside of the door, wrap it around the top of the header and stick the other end of the tape to the top of the glass on the outside of the door.
25 26 With a helper inside the shower, life the unit into place and set it onto a continuous bead of silicone on the threshold QCI-5305 REV 2 19 CERTIFIED 03/01/2019
27 28 QCI-5305 REV 2 20 CERTIFIED 03/01/2019
29 30 QCI-5305 REV 2 21 CERTIFIED 03/01/2019
31 Remove the masking tape holding the glass in place. 32 Open the door about 1/2 way.
33 34 Use the supplied alcohol pad to clean the edge of the glass. Make sure the glass is clean and dry before sticking the vinyl to the glass.
35 36 QCI-5305 REV 2 24 CERTIFIED 03/01/2019
37 38 QCI-5305 REV 2 25 CERTIFIED 03/01/2019
QCI-5305 REV 2 26 CERTIFIED 03/01/2019