Installation Guide

QCI5301 Rev 1 Page 16 Cered 6/5/2017
12 Slide the Header
Mount Brackets into each
Wall Jamb. The 3 holes
face Inside the Shower.
Align the Header Mount
Brackets with the mark
made in STEP 10. Mark the
locations of the mounting
slots as shown.
13 Remove the Header Mount Brackets and drill 1/8” holes at the 4 marked locations. Drill only
through the aluminum Wall Jamb.
Mark from Step 10
14 For easier installation of the Header Assembly, install and then remove the 4 SCR02 Header
Mount Screws.
DO NOT use a power tool to prevent stripping the holes.
PRO-TIP: This step pre-
threads the mounting holes to
make final installation easier.
For even easier installation, a
small amount of candle wax
or bar soap on the threads will
make installation of the screw
easier and will help prevent
stripping the head.
Be sure the mounng
holes are to the inside
of the shower
PRO-TIP: Make the holes near the
top of the adjustment slots. If they
are drilled accurately this will pre-
vent the header from slipping out of
adjustment in the future.