Installation Guide

QCI5301 Rev 1 Page 2 Cered 6/5/2017

Installation Notes:

 A minimum of 1” thread engagement is required of all fasteners. Depending on the application

the customer maybe required to supply the proper fasteners to ensure adequate engagement.

 Wall Jambs and Guide maybe installed using wall plugs where no backing is found.

 Use caution to not pierce plumbing or electric lines while installing door hardware.

 Cover the drain with tape prior to installation to prevent loss of small parts.

 Unpack your unit carefully and inspect for freight damage. Lay out and identify all parts using

the instruction sheet as a reference. Before discarding the carton, check to see that no small

hardware parts have fallen to the bottom of the box. If any parts are damaged or missing, refer

to the description noted in the instructions when contacting your dealer for replacements.

Maintenance:

Two primary materials are used to manufacture your new shower enclosure: tempered glass and

anodized aluminum. To assure a long lasting finish on the enclosure, wipe it down with a towel

after each use.

For occasional, more concentrated cleaning efforts, we find that Lysol® Non-Abrasive Bath-

room Cleaner works extremely well. Be sure that any over spray falling on the aluminum frame is

rinsed thoroughly and dried. Many over-the-counter cleaners, if applied to the aluminum and left

on, will harm the metal finish and cause permanent damage even though their directions indicate

safe use on shower doors. Never use a scouring agent to clean the aluminum.

For units with AquaglideXP please use Maintain spray from the maintenance on the glass.

Please contact customer service for details and to purchase the maintenance kit.

Tools:

To install your New Shower Enclosure, you may need the following:

 Pencil

 Low Tack Tape

 Tape Measure

 4’ & 6’ Levels

 #2 Phillips Screwdriver

 Hack Saw

 Caulk Gun

 Clear Silicone Caulk

 Suction Cups

 Drill

 1/8” & 3/16” Drill Bit

 3/16” Masonry Drill Bit

 Center Punch

 Files

 This unit is best installed by two people.

 Handle the glass panels carefully and protect the edges. Safety tempered glass is very re-

sistant to breakage, but the sharp corners of the panels can damage tile and flooring surfaces.

 The glass can break if unequal pressure is applied during installation.

 Please wear safety glasses whenever drilling or cutting. When drilling holes in ceramic tile or

marble, use a center punch and hammer to carefully break the glazed surface to prevent skid-

ding when drilling.

NOTE: Tempered glass cannot be cut.

Safety Notes: