Installation Guide
QCI5301 Rev 1 Page 24 Cered 6/5/2017
28 Slightly loosen the screws in both Outer Panel Roller Assemblies. Turn the Anti-Jump to
vertical to latch them to the Header Assembly.
It maybe necessary to press the Door Assembly towards the header at the roller locations. Retight-
en the screws after adjusting the Anti-Jump.
View from Inside
Adjust the An-Jump to latch
seat under the lip on the header
29 Push the Outer Panel to the same side as the
Inner Panel. Slide the Bottom Guide between the
panels and center it along the length of the Track.
Then pre drill the holes using the 1/8” drill bit.