Installation Guide
QCI5301 Rev 1 Page 25 Cered 6/5/2017
32 Header Cut Length [HC]:__________” From STEP 7
Subtract : 1/2”
Anti Jump Length [AJ]:_______”
Cut the Anti-Jump Vinyl to length [AJ].
Then cut Anti-Jump Vinyl in half to make 2 pieces of equal length.
30 Fasten the SCR30 (2) screws to
the Track Assembly through the Bot-
tom Guide.
31 Carefully move each panel to its closed position. As required, slightly loosen the screws in
each roller to adjust each panel. The panels should contact both bumpers on the wall they close
against.
After adjustment for gaps at the walls, final tighten the screws in each roller.