User manual

• If it is no longer possible to operate the product safely, take it out of
operation and protect it from any accidental use. Safe operation can no
longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a
low height can damage the product.
• This device is not intended to be used by persons (including children) with
reduced physical, sensory or mental abilities or lack of experience and /
or lack of knowledge unless they are supervised by a person responsible
for their safety or have received instructions on how to use the device.
• Children should be supervised to ensure that they do not play with the
device.
• Cleaning, maintenance and user maintenance must not be performed by
children without supervision.
• Never touch the product with wet or moist hands.
• The device was constructed according to protection class II. Only a
proper mains socket (220 - 240 V/AC, 50 Hz) of the public supply net
must be used as voltage source.
• Before connecting the appliance to the power supply, check that the
power supply voltage and current rating corresponds with the power
supply details shown on the appliance rating label.
• The mains outlet must be located near to the device and be easily
accessible.
• Never pull the mains plug from the socket by pulling at the cable. Always
pull it from the mains socket using the intended grips.
• Unplug the mains plug from the mains socket if you do not use the device
for an extended period of time.
• For safety reasons, always unplug the device in case of a thunderstorm.
• Make sure that the mains cable is not squeezed, bent, damaged by sharp
edges or put under mechanical stress. Avoid excessive thermal stress
on the mains cable from extreme heat or cold. Do not modify the mains
cable. Otherwise the mains cable may be damaged. A damaged mains
cable can cause a deadly electric shock.
• Do not touch the mains cable if it is damaged. First, power down the
respective mains socket (e.g. via the respective circuit breaker) and
then carefully pull the mains plug from the mains socket. Never use the
product if the mains cable is damaged.
• Regularly check the mains plug and mains cable for damage. If the power
cable of the device is damaged, it must be replaced with an identical
power cable.
• To prevent risks, damaged power cables may only be replaced by the
manufacturer, a professional workshop appointed by the manufacturer,
or a similarly qualied person.
• Never plug in or unplug the mains plug when your hands are wet.
• Always lay cables so that nobody can trip over or become entangled in
them. This poses a risk of injury.
• Never pour any liquids over electrical devices or put objects lled with
liquid right next to the device. If liquid or an object enters the interior
of the device nevertheless, rst power down the respective socket (e.g.
switch off circuit breaker) and then pull the mains plug from the mains
socket. Do not operate the product anymore afterwards, but take it to a
specialist workshop.
• Never use the product immediately after it has been brought from a cold
room into a warm one. The condensation generated could destroy the
product. Allow the device to reach room temperature before connecting
and using it. This may take several hours.
• Operate this product away from an open window to avoid a short circuit
caused by dripping or rain water.
• Ensure that there are no parts, such as textiles, in which the blades can
get caught up. Be careful with long hair or curtain: These can be sucked
in by the air ow!
• Never leave the product unattended during use.
• Never cover the product when in use.
Operating instructions
Table fan, 30 W, 18 cm, black
Item no. 1519473
Intended use
The product is used for indoor air circulation. The speed can be set in 3 levels.
The direction of airow can be adjusted vertically. Power is supplied via a normal
household power outlet.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g.
in bathrooms, must be avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If
you use the product for purposes other than those described above, the product may
be damaged. In addition, improper use can cause hazards such as short circuiting,
re, electric shock etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All
company names and product names are trademarks of their respective owners. All
rights reserved.
Delivery content
• Table fan
• 4 x screws
• 4 x dowels
• Operating instructions
Up-to-date operating instructions
Download the latest operating instructions from our website www.conrad.com/
downloads or scan the printed QR code. Follow the instructions on the website.
Description of symbols
The symbol with a ash in a triangle indicates health risks e.g. due to
electric shock.
The symbol with an exclamation mark in a triangle indicates important
instructions contained in these operating instructions that must be followed.
The arrow symbol alerts the user to the presence of important tips and
notes on using the device.
Use the product in closed indoor spaces only.
Read the user manual before using the product.
Protection class II
Safety instructions
Read the operating instructions carefully and especially observe the
safety information. If you do not follow the safety instructions and
information on proper handling in this manual, we assume no liability
for any resulting personal injury or damage to property. Such cases
will invalidate the warranty/guarantee.
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may
become dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong
jolts, high humidity, moisture, ammable gases, vapours and solvents.
• Do not place the product under any mechanical stress.