CA Prop 65

29
Date of issue
Version
Product name: BATHWORKS® Bathtub,
Tile & Sink Coating
29 January 2015
Exposure controls/personal protection
8 .
If workers are exposed to concentrations above the exposure limit, they must use
appropriate, certified respirators. Use a properly fitted, air-purifying or air-fed respirator
complying with an approved standard if a risk assessment indicates this is necessary.
Respirator selection must be based on known or anticipated exposure levels, the
hazards of the product and the safe working limits of the selected respirator.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
When there is a risk of ignition from static electricity, wear anti-static protective clothing.
For the greatest protection from static discharges, clothing should include anti-static
overalls, boots and gloves.
Skin
Respiratory
:
:
Environmental exposure
controls
:
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment will
be necessary to reduce emissions to acceptable levels.
>37.78°C (>100°F)
Liquid.
64% (v/v), 56.84% (w/w)
Not available.
Not available.
0.95
Not available.
0.89 kPa (6.7 mm Hg) [room temperature]
Insoluble in the following materials: cold water.
Not available.
Not available.
Boiling/condensation point
Melting/freezing point
0.52 (butyl acetate = 1)
Physical and chemical properties
Physical state
pH
Specific gravity
Vapor pressure
Vapor density
Volatility
Evaporation rate
Solubility
Odor
Color
:
:
:
:
:
:
:
:
:
:
:
:
Flash point
:
Closed cup: 27.22°C (81°F)
Explosion limits
:
Lower: 1%
9 .
Partition coefficient: n-
octanol/water
:
Not available.
% Solid. (w/w)
:
43.16
Density ( lbs / gal )
:
7.93
Yes.
:
Material supports
combustion.
Stable under recommended storage and handling conditions (see Section 7).
Reactive or incompatible with the following materials:,oxidizing materials,strong acids,
strong alkalis
Under normal conditions of storage and use, hazardous polymerization will not occur.
Under normal conditions of storage and use, hazardous decomposition products should
not be produced.
Avoid all possible sources of ignition (spark or flame). Do not pressurize, cut, weld,
braze, solder, drill, grind or expose containers to heat or sources of ignition.
Stability and reactivity
Stability
Conditions to avoid
Materials to avoid
Hazardous decomposition
products
Hazardous polymerization
:
:
:
:
:
10 .
Page: 5/8
Canada - Mexico