Manual

BatteryMINDer
©
Model 12248-A-ODY
Rev. D-050509 Page 7 P/N VDC12248-A-ODY-MNL
Do not connect clip to carburetor, fuel lines, or
sheet metal body parts. Connect to heavy gauge
metal part of frame or engine.
h. When disconnecting charger, disconnect charger from
AC outlet, then remove clips from vehicle chassis, and battery
posts.
Operating instructions for charge information.
FOLLOW THESE STEPS WHEN BATTERY IS
OUTSIDE OF VEHICLE OR EQUIPMENT.
A SPARK NEAR THE BATTERY MAY CAUSE
BATTERY EXPLOSION. TO REDUCE RISK OF A
SPARK NEAR BATTERY:
a. Check polarity of battery posts. POSITIVE (POS,P,+)
usually has a large diameter than NEGATIVE (NEG, N, -)
battery post.
b. Connect (RED) charger clip to (POS+) post of battery.
c. Position yourself and free end of cable as far away from
battery as possible, then connect NEGATIVE (BLACK) charger
clip to free end of cable.
d. Do not face battery when making final connections.
e. When disconnecting charger, always do so in reverse
sequence of connecting procedure and break first connection
while as far away from battery as practical.
Do not attempt to permanently install any
charger not specifically designed for permanent
installation, especially in a wet / marine
environment