Operation Manual
Start the programme with the start / stop button:
Close the door then programme starts.
Attention
Avoid opening the door during the washing process. This interrupts the
washing process, and hot steam will escape. When the door is closed, the
programme will continue.
An audio signal with an interval of 10 seconds warns you to switch your
machine off when the selected washing program ends. This audio signal
warns you for a duration of 5 minutes and then turns off.
Open the door Press the on/off button after the programme is completed.
The indicator lights will go off.
Close the water tap.
Pull out the plug.
Allow your dishes to cool for 15 minutes, with the door open.
Unload the dishes. Begin with the lower basket.
How to use your dishwasher:
Open the water tap.
Plug to the mains.
Open the door and load the dishwasher. Check if both upper and lower
spray arms move freely.
Pour (Put in) the detergent.
Push in the on/off button and check that the display lights comes on.
Check the salt and rinse aid level indicators before you start the machine.
If necessary add salt and rinse aid.
Use the programme selection button to choose your washing programme.
- When there are few dishes, additionally use the Half load button.
PROGRAMME TABLE
Cleaning temperature
QUICK REFERENCE GUIDE
Used dishes
which are to be
washed at a later
time
Dessert and
coffee dishes with
food leftovers
which are not
dried on
Glasses, dessert
and coffee dishes
with food leftovers
which are not
dried on
Normally dirty
dishes with starch
containing food
leftovers which
are not dried on
Normally dirty
dishes with food
leftovers which
are not dried on
Especially dirty
dishes with food
leftovers which
are dried on
Dishes with food
leftovers which
are dried on
especially hard;
dishes which are
to be cleaned
with an unusual
amount of heat
Normally dirty
dishes with food
leftovers which
are dried on
The programme
process is adapted
to the degree to
which the dishes
are dirtied
GB
5
Time Delay button
8
Programme selection button
7
Half Load (1/2) button
6
Start/Stop button
The consumption values shown in the table were determined under standard conditions. For this reason, deviations are possible under practical conditions.
** Reference programme für test institutes
The tests in accordance with EN 50242 must be carried out with a full salt container of the water softener, a full reservoir for the rinse aid and the testing programme.
Load capacity : 10
1
On/Off button
2
Rinse aid level indicator light
3
Salt level indicator light
4
Display
Programme number
Programme name
Detergents
Degree of dirtiness
Suited to
Programme process
15 cm³
15-25 cm³
+ 5 cm³
Duration (min)
Energy (kWh)
Water (I)
medium to high
55°C-65°C
8
-
x
-
Auto
-
-
1
Pre-wash
End
-
-
-
Pre-wash
35°C
Few
2
35°C wash
Cold rinse
Cold rinse
End
x
-
-
30 Min.
70°C
7
High
50°C
Pre-wash
70°
wash
Cold rinse
Cold rinse
Dry
End
-
x
x
Hygiene+
70°C
High
6
50°C
Pre-wash
70°
wash
Cold rinse
Cold rinse
Dry
End
-
x
x
Intensive
55°C
medium
5
Pre-wash
55°
wash
Clear rinse
Clear rinse
Dry
End
-
x
Normal
x
50°C
medium
4
Reference **
Pre-wash
50°
wash
Clear rinse
Clear rinse
Dry
End
-
x
x
Eco
40°C
Few
3
Pre-wash
40°
wash
Clear rinse
Clear rinse
Dry
End
-
x
-
Delicate
Attention
Please read the operating manual prior to operating the machine for the first time.
15
-
3,4
30
0,75
9,6
71
12,4
0,80
170
12
1,01
96
1,00
12,4
128
1,40
17,2
124
1,67
15,4
112 -130
1,00 -1,25
9,6 -18,4
1
4 5 687
2 3