Operation Manual

On/off button
You turn your dishwasher on / off with this button. When turning
on, the indicator light for the last used programme will light up.
Start / Stop button
You use this button to start the selected programme; the light
on the button lights up.
Stop the programme with the start / stop button if you would
like to open the door once the dishwashers washing programme
is running.
Half Load (1/2) button
When there are few dishes, you press this button after pressing
the programme selection button. When turning the dishwasher
on, the indicator light on the button lights up. This function
helps you to save water and energy.
Display
Water hardness level and Time Delay for the selected
programme are displayed.
Time Delay
This option enables you to start the selected programme with
a delay of 1  24 hours.
Time Delay is adjusted by pressing plus delay button near the
display. After adjusting the required Time Delay, press Start /
Stop button and close the door. At the end of the delay set, the
programme starts automatically.
During a programme, Time Delay option does not function.
Programme selection buttons
Use the programme selection button to select the desired
programme. The corresponding programme light lights up.
How to cancel the washing programme
To cancel a programme while the machine is operating:
Press start/stop button. The indicator light will go off.
Press start/stop button for 5 seconds again. The indicator light
will start flashing. Close the door. The machine will drain the
water inside the machine for 45 seconds. The programme is
cancelled when start/stop indicator light goes off. Then, you
can choose and start a new programme.
! Important: Depending on the stage of the programme you
have cancelled, there may be detergent residue or rinse aid
inside the machine and on the load. Make sure the items in
the dishwasher are not used before washing properly.
How to change the washing programme
To change the programme selection while the machine is
operating open the door.
Press start/stop button. The indicator light will go off.
Select the new programme. Press start/stop button. The
indicator light will be on and close the door new programme
will start.
! Important: The new programme will NOT start right from the
beginning. It will start from the stage last carried out by the
previous programme selection.
Attention
- Depending on the length of the terminated programme
- detergent and rinse aid may still be in the dispensers.
Function buttons Control indicator lights
Salt level indicator light
3
If this indicator light comes on, you have to refill
rinse aid.
You can also tell whether rinse aid must be refilled
by looking at the rinse aid dispenser. When the
visual fill indicator is dark, there is enough rinse
aid in the dispenser.
When the colour is light, open the dispenser and
refill rinse aid.
When this indicator light comes on, you must refill
special salt.
In machines which do not possess an electrical
salt indicator, the salt content can be read on the
container for the salt. When the visual fill indicator
is dark, there is enough salt in the container.
When the colour is light, open the container and
add dishwasher salt.
Rinse aid level indicator light
2
FUNCTION BUTTONS
GB
17 2817 01 00-005019 496 96702
S
A
L
Z
T
U
Z
S
A
L
T
S
E
L
Empty
S
A
L
Z
T
U
Z
S
A
L
T
S
E
L
Full
Note for Testing Institutes
The necessary information for performance testing will be provided upon
request. The request can be done by e-mail through:
[e-mail]
Please do not forget to write the model code and stock code information of
the appliance besides your contact information in the e-mail. The model code
and stock code information can be found on the rating label, which is placed
on the side of the door.
2
3
2
3