Quick Start Guide

5019 496 90389
GB
GSIH 6497
Quick Reference Guide
Before using the dishwasher, read the user instructions!
BK/I/B/GB
(We reserve the right to make technical modifications)
Add regeneration salt
Only add regeneration salt immediately
before starting a wash programme.
Add rinse aid
“Delayed start” buttons
The wash cycle can be programmed to start
after 1-9 hours. Then press the Start button.
The wash programme will start at the set
time.
“Half Load” button
The half load cycle can be used for the upper
and lower rack. Select the required
programme then press the “Half Load”
button. The light comes on and goes off at
the end of the programme.
The “Half Load” function can be used with
programmes marked with an
*
.
1) Reference programme for energy label in
compliance with EN 50242 regulations;
2) Refer to “User instructions“;
3) Program data obtained in conformity with
European standard EN 50242. Values may vary in
relation to usage, e.g.: different loads, water
temperatures - above or below 15°C - as well as
water hardness and power supply voltage, etc.
Programme selector knob
On / Off button
Start button
Switches “on” when the dishwasher is
operating. Flashes when a fault occurs.
Switches off at the end of the programme.
Indicators
Wash cycle
Pre-Rinse Washing Drying
Programme
end
Options
Programme chart
Detergent
2)
Consumption
3)
Programmes Loading instructions A B
Litres kWh Minutes
Pre-Rinse cold
Crockery to be washed later. - - 5.0 0.02 10
Rapid 30 min 40°C
Lightly soiled crockery with no
dried-on food.
X - 13.0 0.70 30
Normal
1) *)
50°C
Normally soiled crockery. X X 16.0 1.05 140
Intensive 70°C
Heavily soiled crockery, especially
pots and pans.
X X 17.0 1.90 135
Important information for Test Laboratories:
For detailed information on the EN comparison test and other tests, contact the following address:
“[e-mail]”.