Quick Start Guide

ManualsBrandsBauknecht ManualsDishwasherGSIP 6127

5019 496 90463

Quick Reference Guide

Before using the dishwasher, read the user instructions!

BK/I/B/GB

(We reserve the right to make technical modifications)

GSIP 6127

Time and failure display

Indicates in hours the time remaining until the start of

the wash cycle. Switches off at programme start and

indicates the remaining time in hours and minutes.

“F....” Information for the After-Sales Service

“Delayed start” button

The wash cycle can be programmed to start after

1 - 24 hours. With each successive touch of the button,

the delayed start indicator increases by 1 hour, and after

24 returns to 00. Then press the Start button. The

dishwasher will start at the set time.

“Half load - Multizone” button

Load the upper

lower rack

only

This function can be used with any programme.

Press once = upper rack (the indication lamp/symbol comes on)

Press twice = lower rack (the indication lamp/symbol comes on)

Press 3 times = Off (half load function deactivated).

When washing without the top rack, press the “Half

Load” button twice, or “Lower rack wash” (the

corresponding LED/symbol comes on).

Antibacterial rinse

4) 5)

This function adds an antibacterial rinse at the end of the

wash cycle, thereby guaranteeing a perfectly clean and

sanitized load. The lamp will light up when the function

is activated. If the temperature is not maintained during

the antibacterial cycle (e.g. if the door is opened and

remains open for a long time), the lamp will start blinking

to indicate that sanitation is not guaranteed.

1) Reference programme for energy label EN 50242;

2) Refer to “User instructions”;

3) Programme data obtained in conformity with European

standard EN 50242. Values may vary in relation to usage,

e.g.: different loads, options, water temperatures - above

or below 15°C - as well as water hardness and power

supply voltage, etc.

4) The bacteria removal efficiency has been tested by the

Institut Pasteur de Lille (France), based on the NF EN

13697 standard of November 2001.

5) These programmes can be used with the Antibacterial

rinse option.

6) Energy saving programme with prolonged drying cycle.

Programme selection button

On / Off button

Start button

Switches “on” when the dishwasher is operating.

Flashes when a fault occurs. Switches off at the

end of the programme.

Options

Programme chart

Detergent

Consumption

Programmes Loading instructions A B

Litres kWh Minutes

Sensor +

40-70°C

Lightly, normally or heavily

soiled crockery, including pots

and pans.

X X 7.0-17.0 0.99-1.58 65-170

Pre-Rinse cold

Crockery to be washed later. - - 4.0 0.03 14

Glass 40°C

Light soiling, for example

glasses and cups.

X - 10.0 0.85 100

Rapid 30 min 40°C

Lightly soiled crockery with no

dried-on food.

X - 10.0 0.65 30

Eco

1) 5) 6)

50°C

Normally soiled crockery. X X 13.0 1.05 195

Important information for Test Laboratories:

For detailed information on the EN comparison test and other tests, contact the following address:

“nk_customer@whirlpool.com”.

Summary of content (4 pages)

PAGE 1
Before using the dishwasher, read the user instructions! GB Quick Reference Guide GSIP 6127 Options 3) Time and failure display Programme selection button Indicates in hours the time remaining until the start of the wash cycle. Switches off at programme start and indicates the remaining time in hours and minutes. “F....” Information for the After-Sales Service “Delayed start” button The wash cycle can be programmed to start after 1 - 24 hours.
PAGE 2
How to use the appliance Further indications are given in the single chapters and in the user instructions. Switch on the appliance Select, save, and supply the detergent Check the rinse aid level Check the regeneration salt level Load the racks Press the ON / OFF button. (The first time you use the appliance and when using a different type of detergent) A BC 1. Select the third programme from the top in the relative table. 2. Press the Start button for about 7 seconds until the display changes. 3.
PAGE 3
Dishwasher loading instructions and racks provided depending on the model Upper rack: B Crockery holder (A): Depending on the position, for long-handles utensils, cups and plates. Glass holder (B): Long-stemmed glasses. Long-handled utensils (e.g. carving forks, knives) must be arranged with the sharp end facing in towards the appliance. A Half Load: C Load the upper rack (see description of Options). Place the cutlery basket (C), if provided, in the upper rack.
PAGE 4
What to do if... If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see also the corresponding chapter in the user instructions). Problem The appliance is not working If crockery is not perfectly dry If crockery is not perfectly clean Cause Remedy • No water supply. • Open the tap. • The appliance does not load sufficient water. • Clean the water supply tap filter. • Ensure there are no kinks in the water hose.