User manual

21
o Push the top and bottom baskets fully back into position.
o Add detergent
o Turn the appliance on by using the ON/OFF button.
o IMPORTANT: Wait for 5 seconds before pressing the
program selection button, otherwise the appliance may
not function correctly.
o Press the program selection button to choose an appropriate
wash program for the load that you are washing. The relevant
program indicator neon will light to show which program you
have selected.
o Select any program options that you want to use (e.g. delay
start or half load).
o Close the door firmly, so that you hear the door lock click shut.
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.
Changing the wash program
IMPORTANT: This should only be attempted when the cycle has
only just started, otherwise the detergent tablet may have
already released or you could have hot water escaping.
o Slightly open the door of the appliance and turn off the power
using the ON/OFF button.
o Wait for a minute before fully opening the door of the appliance.
o Turn the appliance on by using the ON/OFF button and wait for 5
seconds before pressing the program selection button.
o Press and hold down the program selection button for 3 seconds
to cancel the wash program. Then use the program selection
button to choose the correct wash program.
o Select any program options that you want to use (e.g. delay
start or half load).
o Close the door firmly, so that you hear the door lock click shut.
o After a few seconds, you will hear the appliance begin to fill with
water and the wash program will have started.