User manual

28
E3
o Longer heating time- not reaching the required temperature.
9 Malfunction of the temperature sensor or heating element.
9 Call Baumatic Service Department.
E4
o The machine has sensed water in the base.
9 Check that the outlet hose is not kinked or crushed.
9 Check that there are no blockages in the drain hose or the drainage
system that the appliance is connected to.
9 The drain pipe may be placed in too high a position or incorrectly.
Check the installation instructions and ensure that the installation is
correct.
E5
o Switch cannot shut off automatically- program not finishing its
cycle.
9 Low voltage or power switch failure.
9 Call Baumatic Service Department.
E6
o Open circuit
9 Thermistor
9 Call Baumatic Service Department.
E7
o Short circuit
9 Thermistor
9 Call Baumatic Service Department.
o Once you have taken action to rectify the problem that has
caused the fault code to appear, plug the machine back into your
mains power supply.
o Turn the machine on using the ON/OFF button and wait for 5
seconds.
o Press and hold down the delay start button and the ON/OFF
button, until the appliance switches off.
o Wait for 5 seconds, and then switch back on the appliance using
the ON/OFF button.
o Wait for a further 5 seconds before attempting to set a wash
program, using the program selection button.