Instruction manual
Witheachwashcycle.
Compartment
For programm es with pre-wash on ly.
(Follow the user instr uctions!)
Electric indicator on control panel (if provided).
Check the rinse aid level
Load the baskets
Select a programme
Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few minutes (about 15 minutes) before unload ing the dishwasher to avoid handli ng
the dishes and utensils while they are still hot and more susceptible to break.
They will also dry better.Unload the appliance, starting from the lower b asket.
Changing the programme
Add forgotten dishes in the
dishwasher.
Scrape off any large amount of leftover food. Soften remnants of burnt foo d in pans,
then l oad the baskets. Refer to the dishwasher loadin g instructions.
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched
off during a wash cycle.
Op en t he door car ef ully.
Hot st eam may esc ape
when the door is opened!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance
For detailed operating method read the corresponding conte nt on t he instruction man ual.
Close the door, t urn on the water tap. The machine will start working
after about 10 seconds.
Press the Programm e Button, the selected programme indicator lights up.
( See the section entitled Opera tiong instructio n )“”
Open the door, press the On/Off button to switch on the appliance.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the door
, press the program button more than 3 seconds, the machine will be in
standby state, then you can change the program to the desired cycle setting.
1.Open the door a little to stop the washing.
2.After the spray arm s stop working, you can open t he door
completely.
3.Add forgotten dishe s.
4.Close the door, the dishwasher will r un after 10 seconds.
AB