Specifications

HBZTX6-IN-4 Page 19
8 Using The On-Screen Menus
8.1 Introduction
The menus are used to configure your ZTX6. The main menu is shown below followed by a
brief description of each of the sub-menus.
0 Main menu
Set new password menu
Alter sequence menu
Camera/Rx menu
Alarms menu
System settings menu
Keyboard menu
Installer setup menu
Exit menu
Set new password menu
Change the operator and/or installer passwords.
Alter sequence menu
Set up the camera sequences with lists of cameras and dwell times. There are 8 sequences.
Camera/Rx menu
Camera input and receiver enable, set camera titles, receiver options (telemetry type and
preset type).
Alarms menu
Decide alarm display modes (NONE, LAST, STACK, SWITCH and ROTATE),
Decide responses to alarms and network events,
Enter messages for display during responses,
Decide the sense of alarm inputs and alarm outputs (normally-open or normally-closed) and
Choose how the alarms are reset: TRANSP. (contact-closure),
TIMEOUT (time-out) or
ACK (manual reset) and
Decide the state the system returns to on completion.
System settings menu
Enable/disable preset setting mode and position the on-screen displays.
Keyboard menu
Defines which monitors, cameras and camera telemetry an individual keyboard can access.