Specifications

HBZTX6-IN-4 Page 37
The default setting is ALLOWED for every one.
Note:
If, in the Camera/Rx menu you have selected ‘Input present : NO’ or ‘Rx attached
: NO’ then it is not necessary to also set them to BARRED here.
9.15 Installer Setup menu - Version Numbers
This menu displays software and firmware version numbers, and allows
storage of your own default system settings
changes to the Unit ID
restoration of the factory defaults
swapping of zoom buttons for ZTX5 replacement.
Receiver tuning mode is only used in special circumstances. Its function is to leave the
telemetry running continuously by sending a WIPE command once per second until it is
deactivated.
To change the Unit ID:
CAUTION: if you change the Unit ID you must ‘Save and Exit’ the menus then, reset your
ZTX6 by removing the power for 5 seconds. You will not lose any settings.
• Select the field using the up/down-arrow keys or joystick
• Type the new Unit ID on the numeric key-pad
• Exit the menus using the ‘Save and Exit’ option
• Reset your system by removing the power for 5 seconds
Your settings will not be lost.
To store your own default system settings:
• First setup all the camera titles, monitors, alarms etc.
• Select ‘Save to user defaults’
To restore system settings to the user defaults:
• Select ‘Restore user defaults’
To restore system settings to the factory defaults:
• Select ‘Restore factory defaults’
8 Installer Setup menu
Software Version :1234
Firmware Version :56789ABC
Unit ID : 09
Save to user defaults
Restore user defaults
Restore factory defaults
Receiver tuning mode
Zoom swap :NO
Return to main menu