Technical data

Programming
120-393 632.4 04.08 Fh
PARAMOUNT two 30 - 115 kW 45
Parameters with the program numbers 1-54 are individual parame-
ters of the operating unit and the room device and may, therefore,
be set differently on both devices. All parameters from program
number 500 onwards are stored on the controller and, therefore,
identical. The value modified last, is the valid value.
Flow nominal value 2
I
DHW temperature 1
8830 I
DHW nominal value
I
DHW temperature 2
8832 I
DHW charging temp
8836 I
Buffer temp 1
8980 I
Information values
The display of the information values depends on the operation status!
Fault message
E
SW Diagnosis code
E
Message
E
State manual control
E
Controller stop nominal value
E
Screed nominal value actual
E
Screed day actual
E
Room temperature
E
Room temperature minimum
E
Room temperature maximum
E
Boiler temperature
E
Drinking water temperature 1
E
Collector temperature 1
E
Status boiler
E
Status solar
E
Status DHW
E
Status heating circuit 1
E
Status heating circuit 2
E
Outside temperature
E
Buffer temp 1
E
Room temperature 1
E
Room nominal value 1
E
Room temperature 2
E
Room nominal value 2
E
Operation display FA
E
1.E = Enduser; I = Commisioning; F = Engineer
Function
Prog.
-No.
Set-
ting
level
1
Standard value
Modi-
fied
value