Quick Start Manual

11.0 Fitting the Outer Case

11.1 Fitting The Outer Case

1. Fit the outercase to the appliance ensuring that the

four slots in the side flanges align with the hooks on

the chassis (Fig. 38).

2. Insert the two fixing screws into the sides of the

chassis (Fig. 39).

3. Close the lower door panel against the retaining

magnets (Fig. 39).

4. Instruct the user in the operation of the boiler

controls. Hand over both the Users Operating and

Installation and Servicing Instructions, giving advice on

the necessity of regular servicing.

5. Advise the user that a plume of vapour from the

flue terminal is normal, and that there is no need for

concern.

6. Advise the user that if intelligent pre-heat is on, pre-

heating will not occur for the first week of operation.

7. Set the User preferences. See User Label on lower

door panel (Fig. 38) or user’s operating instructions

(set CH/DHW temperatures).

8. Carefully read and complete all sections of the

Benchmark Commissioning Checklist at the rear of this

publication that are relevant to the appliance and

installation. These details will be required in the event

of any warranty work. The publication must be handed

to the User for safe keeping and each subsequent

regular service visit recorded.

9. For IE, it is necessary to complete a “Declaration of

Conformity” to indicate compliance to I.S. 813. An

example of this is given in I.S. 813 “Domestic Gas

Installations”. This is in addition to the Benchmark

Commissioning Checklist.

Fig. 38

Fig. 39

Lower Door Panel

Outercase Fixing Screws

Lower Door Panel

Retaining Magnet

User

Label