Owner`s manual

RPC SERIES OWNER’S MANUAL
DETAILED OPERATION AND CONFIGURATION
________________________________________________________________________________
49
Enter the Gateway address (Example:
200.4.5.50), followed by <cr>. The RPC
resumes the configuration menu
Default
Gateway address is 0.0.0.0.
If you fail to
enter the Gateway address is dotted decimal
form, the RPC responds again:
Enter Gateway address in dotted decimal form:
The RPC responds indefinitely with the
same request until the Gateway address is
entered in the correct form.
Unit ID
From the configuration menu, select #4,
“Unit ID.” The RPC responds:
Enter Unit ID (64 chars max):
Enter the RPC Unit ID, followed <cr>. The
RPC resumes the configuration menu.
Default Unit ID is RPC-3.
Access
Login Setup allows the user to enable or
disable username and password login for
both serial and network ports. If the features
are enabled, the RPC requires username and
password entry before allowing access to the
unit.
To configure the login setup, select #5,
“Access,” from the configuration menu,
followed by <cr>. The RPC Series responds
with the following Login Setup menu: