- NETGEAR Modem Router Reference Guide

Reference Guide for the Model RM356 Modem Router

7-2 TCP/IP Configuration

Remote Node Setup

See Chapter 5, “Remote Node Configuration,” for information about using the protocol-

independent parameters on Menu 11.1 - Remote Node Profile. Use the fields described in

Table 7-1 to set the protocol-dependent parameters.

To set the protocol-dependent parameters:

Select Yes in the Edit IP field of Submenu 11.1 - Remote Node Profile.

Press [Enter] to display Menu 11.3 - Remote Node Network Layer Options.

Edit the options in Menu 11.3 described in Table 7-2 on page 7-3.

Press [Enter] at the Press ENTER to Confirm... prompt to confirm your selections and

return to the previous menu.

Press [Esc] at any time to cancel your selections.

Continue to the end of Menu 11.1 and press [Enter] to save the selections you made in

Menu 11.3.

Note:

If you are configuring the router to receive an incoming call, you must also set

the default dial-in parameters in Menu 13 (see Chapter 6, “Dial-In Configuration”).

Table 7-1. Fields in Menu 11.1 - Remote Node Profile Fields

Field Description

Rem IP Address Enter the IP address of the router at the remote site. If the remote router uses a

different IP address than the one entered here, the call will be terminated. A static

route will be created to the network address of the remote router. Note that if the

remote network uses a netmask other than the standard class netmask, you must

enter the netmask in the Edit IP Options submenu.

Edit IP Press the space bar to chan

e this field to Yes and press [Enter] to display the Menu

11.3 - Remote Node Network Layer Options menu.