Owner`s manual

configuration mode.

IMPORTANT: No characters should be typed

between $BT1<cr> and $CONFIG<cr>. If this

happens, the entire configuration sequence is

discarded and you will have to send the

configuration sequence again.

NOTE: The procedure to access configuration mode for

the V71 from the service port is the same as described

above except you connect your terminal to the service

port which has a fixed serial configuration of 9600 bps,

8 bit word size, 1 stop bit, and no parity. In addition,

you must send $BTX<cr> ($BAYTECHX<cr> on M4 and

M8 DAC) to select the V71 as described in Step 2 where

X = 1 to 16, then proceed to Step 3.

11.1V71 MAIN CONFIGURATION MENU

The V71 responds to the receiving of $CONFIG<cr> with

an identification block and a menu of the available

configuration options similar to the following:

DAC V71 Rev. X.XX

This Module is 1

1) Status

2) Port Select Code

3) Serial Port Configuration

X) Exit Configuration

Enter Request :

NOTE: This menu shows the V71 installed as Module 1.

A line showing the amount of memory is displayed as

the third line in the header if an M03 memory module is

installed.

NOTE: Menu selections are case sensitive. It is

recommended your keyboard be in the CAPS LOCK