Owner`s manual

102
11.6V71 CONTROL PANEL CONFIGURATION
You can review the current status and program the
serial port configuration for the V71 from the control
panel of an M4 with LCD, M8, or M16. To access
configuration mode for the V71 from the control panel,
highlight the appropriate module number using the
arrow keys and the press the SELECT key. The following
menu will appear on the LCD display:

V71 HOST MODULE 01
Display Config 
Serial Port Config 
Exit to Main Menu 

Use the arrow keys (> and ?) to highlight the desired
feature and then press the SELECT key. The "Display
Config" selection displays the current V71 configuration.
For example, if you select "Serial Port Config", the LCD
display will respond with:

Baud Rate 9600 
Press SELECT to Save
Press Arrow Keys to 
Change Value 

Use the arrow keys to make any desired changes in the
baud rate and press SELECT. If the displayed value is
acceptable, press SELECT. The display will follow with
similar menus for parity, data bits, stop bits, XON/XOFF
handshaking in the receive direction, XON/XOFF
handshaking in the transmit direction, and line
interface. After you have made any desired changes,
highlight "Exit To Main Menu" and the front panel
display will return to the main operations menu.