Owner`s manual

128
15.1.1 V50/V73/V74/V75/V76/V86/V87
SERIAL PORT CONFIGURATION
The V50/V73/V74/V75/V76/V86/V87 module translates
data for devices using different serial configurations.
You can set the baud rate, word size, stop bits, parity
and XON/XOFF handshaking for each port. Factory
default configuration on serial ports is 9600 baud rate, 8
bit word size, 1 stop bit, no parity and XON/XOFF
disabled.
15.1.2 V50/V73/V74/V75/V76/V86/V87
PORT DEVICE NAME
You can assign individual names to each port for
reference while the unit is in configuration mode or port
message/data identification. Factory default is Device A
for Port 1, Device B for Port 2, Device C for Port 3, and
Device 4 for Port 4.
15.1.3 V50/V73/V74/V75/V76/V86/V87
HOST MODULE LOCATION
An M Series unit can have multiple host modules
installed on a single unit or multiple units. You can
program the V50/V73/V74/V75/V76/V86/V87 module to
send messages to any individual host module on a
single unit. The host module location consists of the M
Series unit number, module number, and port number.
Messages are sent only to the designated host module
in immediate reporting mode. The factory default host
module location is Unit 1, Module 1, Port 1.
15.1.4 V50/V73/V74/V75/V76/V86/V87