Owner`s manual

141
15.2.4.3 REPORT ALL BUFFERED DATA (RB)
COMMAND
The Report All Buffered Data (RB) command instructs
the module to send all data currently stored in the
buffer for the specified port(s) whether or not it is a
"message" as defined on page 87. Data from the lowest
numbered port specified is sent first. This command
has the following format: RBn<cr> where n is the
desired port number (1 to 4 or 0 for all). If there is no
data in the buffer for the specified port(s), the module
responds with Carriage Return and Line Feed.
15.2.4.4 REPORT SINGLE MESSAGE (RS)
COMMAND
The Report Single Message (RS) command instructs the
V50/V73/V74/V75/V76/V86/V87 module to send a single
message currently stored in the buffer of the specified
port(s). The message sent is the oldest message in the
buffer. This command has the following format:
RSn<cr> where n is the desired port number (1 to 4 or 0
for all). If there are no messages in the buffer for the
specified port(s), the module responds with Carriage
Return and Line Feed.
15.2.4.5 STOP REPORT (SR) COMMAND
The Stop Report (SR) command instructs the
V50/V73/V74/V75/V76/V86/V87 module to stop sending
messages or data after an RA or RB command has been
issued. You can instruct the module to resume sending
messages or data by issuing the desired request for
messages or data command (RA, RB, or RS). This