Owner`s manual

150

module will respond with:

Output Flow Control (Xmit) - Xon/Xoff is ( OFF )

Stop/Restart Output Upon Receiving of Xoff/Xon ? (Y/N) :

You should then enter "Y" to enable XON/XOFF on

transmit or "N" to disable XON/XOFF on transmit.

Following our example, enter "N" and the module will

respond with:

Input Flow Control (Recv) - Xon/Xoff is ( Off )

Xoff/Xon sent based on Buffer - Full/Empty condition ? (Y/N) :

You should then enter "Y" to enable XON/XOFF on

receive or "N" to disable XON/XOFF on receive.

Following our example, enter "Y" and the module will

respond with the reconfigured status for Port 4 as

follows:

Current Module 1 Serial Port Configuration :

+------+------------------+-------+------+------+------+------+------+

+------+------------------+-------+------+------+------+------+------+

| 4 | Device D | 115.2K| 8 | 1 | None | Off | On |

+------+------------------+-------+------+------+------+------+------+

Exit/Save......1 Set Stop Bits.....4

Set Baud Rate..2 Set Parity........5

Set Word Size..3 Set Xon/Xoff......6

Enter Request:

If there are no other changes for this port, send "1"

(Exit/Save) and the module will respond with:

Save Changes Permanently ? (Y/N) :

If you type "Y", the new configuration for the selected

port is stored permanently in non-volatile memory and

the module will subsequently power up at the new

configuration. If you type "N", the new configuration is

stored in RAM and lost once power is removed from the

unit. After you type the desired response to the save

changes prompt, the module will respond with: