Owner`s manual

158
16.13 CONTROL PANEL CONFIGURATION
NOTE: This section does not apply to units equipped
with LEDs.
You can configure the serial parameters for individual
ports, mode of operation, terminate character, and host
module location from the control panel. To access
configuration mode for the module from the control
panel, highlight the appropriate module number using
the
arrow keys and the press the SELECT key. The following
menu will appear on the LCD display for a V74 installed
as Module X (X = 1 to 16):

 M16-V74 MODULE X 
Display Config 
Serial Port Config
Mode Of Operation 

If you push the ? key, the LCD display will respond
with:

Terminate Character
Host Module ID 
Exit To Main Menu 
 

Use the arrow keys (> and ?) to highlight the desired
feature and then press the SELECT key. The "Display
Config" selection displays the current configuration. If
you select "Serial Port Config", the LCD display will
respond with: