Owner`s manual

159

SELECT PORT 
Device A 
Device B 
Device C 

NOTE: The names shown here are the same as the
device names configured from the host module or
service port as described in Section 16.4. Use the
arrow keys to highlight the desired port and then press
the SELECT key. The LCD display will respond with:

BAUD RATE : 9600 
Press SELECT to Save
Press Arrow Keys to 
Change Value 

If the value of the displayed baud rate is correct, press
the SELECT key. If not, use the arrow keys to highlight
the desired baud rate and then press the SELECT key.
The front panel follows with menus for parity, stop bits,
word size, XON/XOFF handshaking in the receive
direction, XON/XOFF handshaking in the transmit
direction, and then back to the "SELECT PORT" menu
shown on the previous page. Make any necessary
changes for the remaining ports or select "Exit To Main
Menu".
IMPORTANT: Be sure to reconfigure the peripheral
equipment to match the new configuration of the
module.
Changes for other parameters in the main menu are
made in a similar manner as serial port configuration.
When you are finished, select "Exit To Main Menu" and