Owner`s manual

169
B.4 M03 MEMORY MODULE BUFFER EXPANSION SIMM
INSTALLATION
Each memory expansion upgrade kit provided by
BayTech includes either a 1MB x 8 or 4MB x 8 SIMM
(single in-line memory module). You may also use third
party SIMMs. The total buffer size can range from 0MB
to 16MB with a minimum of 1MB required for operation.
Please use the following instructions when installing
memory expansion SIMMs.
You will need the following equipment:
1 x phillips-head screwdriver.
1. IMPORTANT: Remove power from the unit by
depressing the power switch on the front of the
unit to OFF. Also remove power cord from the AC
outlet.
2. Remove the M03 module (if already installed) by
loosening the two straight-slot screws that secure
it to the unit chassis and pulling the module out.
3. The memory board has four sockets for memory
expansion. These straight-line sockets are
marked U15, U16, U17 and U18 (refer to Appendix
D.3). Note that one or more of these sockets can
already have a memory module installed.
4. U15 must always be occupied by either a
1MB or 4MB SIMM. Any new memory
expansion module(s) can be installed in any
of the remaining sockets (i.e., U16, U17, or
U18) and need not be installed in any
specific order.