Owner`s manual

3. Access configuration mode by sending

$CONFIG<cr>. Following the example on the

previous page, you would send

$BT1<cr>$CONFIG<cr> to configure Module 1.

Use $BAYTECH1<cr>$CONFIG<cr> on M4 and M8

units.

1.3.3 MAIN UNIT CONFIGURATION

You can program the date, time, and unit number on the

main unit. The date and time are used for event

recording and initiation. When you access configuration

mode for the main unit from a host module or the

service port, you will receive the following menu:

Control Board System Menu

Bay Technical Associates

Unit Number 001

Set Date.................1

Set Time.................2

Set Unit Number..........3

Exit System Menu.........X

Enter Request:

1.3.4 HOST MODULE CONFIGURATION

You can program the port select code and the serial port

configuration (i.e., baud rate, word size, line interface,

etc.) of the V71 host module. If you access

configuration mode for the host module, you will receive

the following menu:

DAC V71 Rev. X.XX

This Module is 1

1) Status

2) Port Select Code

3) Serial Port Configuration