Owner`s manual

1.3.5 V77 ADM-1 CONFIGURATION

You can program the sampling setup, reporting setup,

channel input setup, and enable dynamic configuration

for the V77 ADM-1 analog-to-digital module. If you

access configuration mode for the V77 ADM-1, you will

receive the following menu:

DAC V77 ADM-1 Rev. 1.00

This Module is X

Module Status..................1

Sampling Setup.................2

Reporting Setup................3

Channel Input Setup............4

Dynamic Configuration..........5

Exit...........................X

Enter Selection:

SAMPLING SETUP

By entering a "2" (Sampling Setup), the following menu

will be displayed:

Sampling Method.................1

Sample Start Time...............2

Sample Interval.................3

Sample Rate.....................4

No. of Samples to Average.......5

Exit............................X

Enter Selection:

The three Sampling Methods are Command (upon

request only), Immediate (upon exiting configuration),

and Schedule (where sampling begins at the Sample

Start Time). Sample Interval is the interval between

the start of sampling periods. Continuous sampling is

selected if 00:00:00 is entered. Sample Rate can be

programmed from 1 to 4000 samples per second. The

sample rate for an individual channel is the programmed

rate divided by the number of active channels. Number