Owner`s manual

16
REPORTING SETUP
By entering "3" (Reporting Setup) from the ADM-1 main
menu shown on the previous page, the following menu
will be displayed:
Reporting Method..................1
Report Start Time.................2
Report Interval...................3
Set Host Address..................4
Data Format.......................5
Time Tag..........................6
Terminating Character(s)..........7
Exit..............................X
Enter Selection:
The three Reporting Methods are Command (upon
request only), Immediate (upon exiting configuration
mode), or Schedule (where reporting begins at the
Report Start Time). Report Interval is the interval
between the start of reporting periods. Host Address is
the designated host module where data messages are
sent when using Immediate or Schedule Reporting
Method. Data Format (ADM-1 only) is the format of the
data messages sent to the designated host module
which can be in Hexadecimal or Decimal. When Time
Tag is enabled, a time tag is appended immediately
after the data. Terminating Character(s) is added at
the end of a complete data message and consists of
one or two hexadecimal characters.
CHANNEL INPUT SETUP
By entering "4" (Channel Input Setup) from the ADM-1
main menu shown on the previous page, the following
menu will be displayed:
Range...........................1
Unipolar / Bipolar..............2
Single Ended / Differential.....3
Active Channels.................4
Exit............................X
Enter Selection: