Owner`s manual

Range and Unipolar/Bipolar are used to choose one of

eight different voltage ranges. These are 0 to +10

volts, -5 to +5 volts, 0 to +5 volts, -2.5 to +2.5 volts, 0

to +2.5, -1.25 to +1.25 volts, or 0 to +1.25 volts,

-0.625 to +0.625 volts. You can select a ninth voltage

range which is -10 to +10 volts by installing JP1. Single

Ended/Differential setting is used to select up to 16

single-ended channels or up to 8 differential channels.

Active Channels enables or disables individual channels

for data acquisition.

DYNAMIC CONFIGURATION

By entering "5" (Dynamic Configuration) from the ADM-1

main menu shown on Page 8, the following menu will be

displayed:

Dynamic Configuration Commands are..Enabled

Enable..............................1

Disable.............................2

Exit................................X

Enter Selection:

You can enable or disable the dynamic configuration

mode from this menu. Dynamic configuration mode

allows non-verbose or "on-the-fly" configuration

commands to be issued to the module which are

described in the manual for each respective module.

1.3.6 V78 CRM-1 CONFIGURATION

You can program the Schedule, Reporting Setup, and

Dynamic Configuration for the V78 CRM-1 control relay

module. If you access configuration mode for the V78

CRM-1, you will receive the following menu:

DAC V78 CRM-1 Rev. 1.XX

This Module is X

Module Status...................1