Owner`s manual

NOTE: Reporting Setup is the same as described for

the ADM-1 on Page 9. Dynamic Configuration is

enabled or disabled the same as described for the ADM-

1 on the previous page.

RELAY OPERATING SETUP

By entering "2" (Relay Operating Setup), the following

menu will be displayed:

List Current Schedule..............1

Create/Modify Schedule.............2

Enable/Disable Events..............3

Delete Schedule....................4

Exit...............................X

Enter Selection:

List Current Schedule displays the current relay

schedule. Create/Modify Schedule allows you to

program up to 12 events where each event will energize

or de-energize certain relays at specified days and

times. You can program the Start Time, Interval, and

Duration for each Event Number (1 to 12). Start Time is

the time when the initial occurrence of the selected

event is to transpire. Interval is the interval of time

between the recurrence of the selected event. Duration

is the length of time a specified relay is energized for

the selected event. Enable/Disable Events allows you

to enable or disable individual or all events. Delete

Schedule allows you to delete individual or all events.

1.3.7 V79 PDI-1 & V80 PDI-2

CONFIGURATION

You can program the Sampling Setup, Reporting Setup,

and Dynamic Configuration for the V79 PDI-1 and V80

PDI-2 switch closure and isolated input I/O modules. If

you access configuration mode for a PDI-1 or PDI-2 , you

will receive the following menu:

DAC V79 PDI-1 Rev. 1.XX

This Module is X