Owner`s manual

NOTE: Reporting Setup is the same as described for

the ADM-1 on Page 9. Dynamic Configuration is

enabled or disabled the same as described for the ADM-

1 on the previous page.

SAMPLING SETUP

By entering "2" (Sampling Setup), the following menu

will be displayed:

Debounce Delay..................1

Latch Polarity..................2

Exit............................X

Enter Selection:

Debounce Delay is a variable time-delay (0 to 65535

milliseconds) in recording events intended to prevent

inadvertent noise spikes, relay bounces, etc. as events.

Latch Polarity instructs the PDI-1 or PDI-2 to latch

individual inputs based on a positive going (LO to HI) or

negative going (HI to LO) input.

1.3.8 V74 4-PORT EIA-232 SERIAL

MODULE CONFIGURATION

You can program the Serial Port Configuration, Port

Logical Names, Designated Host Module Location,

Message Terminating Character, Mode of Operation, and

Time Tag for the V74 4-port EIA-232 serial module. If

you access configuration mode, you will receive the

following menu:

(C)Copyright Bay Technical Associates 199X

Model V50/V73/74/V75/76/86/V87 High Speed Serial 4C-232

Revision F.X.XX

Unit: 1, Module: 2

Status......................................1

Serial Port Configuration...................2

Port Device Name............................3

Port I.D....................................4

Designate Host Module Location..............5

Message Terminate Character.................6