Owner`s manual

messages until another Calibrate command is

issued.

CBc<cr> (c=Ch# 1 to 16, 0=all*) Clear Buffer. Clears all old data from the buffer

when a new data set is started.

RAc<cr> (c=Ch# 1 to 16, 0=all*) Report All Buffered Samples.

RSc<cr> (c=Ch# 1 to 16, 0=all*) Report Single Sample if Available

SAc<cr> (c=Ch# 1 to 16, 0=all)* Sample and report a sample at the programmed

Sampling Setup.

* Multiple channels are selected using 4 formats. Examples: SA1,2,3,4,5,6,7,8<cr>,

SA1-8<cr>, SA0<cr>, SA1,2,4-8<cr>

For example, suppose the ADM-1 is installed in Unit 1

Module 15 using a hexadecimal data format with time

tagging enabled. When you select the ADM-1 and issue

the RS1,2<cr> command, the module responds with a

single message from Channel 1 and Channel 2 similar to

the following:

1:15,1 7FE 11/18/93 09:12:22<cr><lf>

1:15,2 7FA 11/18/93 09:12:22<cr><lf>

where 1:15,1 represents Unit 1/Module 15/Channel 1,

1:15,2 represents Unit 1/Module 15/Channel 2, 7FE and

7FA are the hexadecimal representations of the

sampled data from Channel 1 and Channel 2

respectively, 11/18/93 09:12:22 is the time tag which

is the same for both channels in this example, and

<cr><lf> is the Carriage Return and Line Feed

terminating characters.

1.4.3 V78 CRM-1 COMMANDS AND DATA

PRESENTATION

The V78 CRM-1 has eight programmable,

electromechanical, form-C, single-pole-double-throw