Owner`s manual

33
If you issue the RS1<cr> command (Report Single
Buffered Event), the module responds with a message
showing the input status for Channel 1 similar to the
following:
1:15,1 1 11/18/97 09:12:22
where 1:15,1 represents Unit 1/Module 15/Channel 1, 1
indicates the first buffered sample for Channel 1 is
closed, and 11/18/97 09:12:22 is the time tag.
The table below summarizes the commands supported
by the PDI-1 and PDI-2. Please see the V79 PDI-1 and
V80 PDI-2 operator's manual for a more detailed
operational description of the supported commands.
V79 PDI-1 & V80 PDI-2 COMMAND SUMMARY
Command Description
CBc<cr> (c=Ch# 1 to 16, 0=all) Clear Event Buffer. Clear all buffered event samples.
CCc<cr> (c=Ch# 1 to 16, 0=all) Clear Event Counter(s)
CRc<cr> (c=Ch# 1 to 16, 0=all) Clear Event Latch Buffer
RAc<cr> (c=Ch# 1 to 16, 0=all) Report All Buffered Events
RCc<cr> (c=Ch# 1 to 16, 0=all) Report Event Counter(s)
RDc<cr> (c=Ch# 1 to 16, 0=all) Report Event Duration(s)
RLc<cr> (c=Ch# 1 to 16, 0=all) Report Event Latch Data
ROc<cr> (c=Ch# 1 to 16, 0=all) Report Event Counter and Reset
RRc<cr> (c=Ch# 1 to 16, 0=all) Report Event Latch Data and Reset
RSc<cr> (c=Ch# 1 to 16, 0=all) Report Single Buffered Event (first in, first out)
SAc<cr> (c=Ch# 1 to 16, 0=all) Read and report the current state of the selected
input(s).
SLc<cr> (c=Ch# 1 to 16, 0=all) Report Latest Event
* Multiple channels are selected using 4 formats. Examples: SA1,2,3,4,5,6,7,8<cr>,
SA1-8<cr>, SA0<cr>, SA1,2,4-8<cr>