Owner`s manual

You will need a straight-slot screwdriver to perform the

installation.

1. IMPORTANT: Remove power from the unit by

depressing the power switch on the front of the

unit to OFF and also remove the power cord from

the socket.

2. Determine which module slot the module will

install into. Modules are typically installed in

sequence from left to right (facing rear of unit).

The module slots are labeled on the top panel as

"1", "2", ..., "16". If you need to upgrade the

memory on the M03 memory module, please refer

to Appendix B.4 before installing the module into

the base unit.

3. Remove the flat aluminum plate covering the slot

into which the new module will be installed by

loosening the 2 straight slot screws and then

removing the plate from the rear panel. Save the

aluminum plate in the event you have to remove

the module in the future.

4. Install the new module by sliding the horizontal

card edges along the grooves inside the module

slot. Each module has a card-edge connector that

fits into a receptacle inside the base unit. Apply a

moderate amount of pressure to the connector

board of the module until you feel the card edge

connector slip into the receptacle inside. You will

not be able to mount the back plate of the module

to the chassis if the module is not installed all the

way.

5. Mount the back plate of the module to the M

Series chassis by tightening the 2 straight slot

screws on the back plate.