Owner`s manual

56

Bay Technical
Associates
Data Acquisition
Controller


Bay Technical Assoc.
Select Module
00

NOTE: Only modules actually installed appear in the
first screen on the previous page. If a module slot is
empty, a blank is shown. This example shows sixteen
modules installed.
Once all module LEDs are out or the "Bay Technical
Assoc." menu is displayed on the LCD, the unit is in
operations mode and ready to accept commands and/or
data. The commands consist of data commands,
dynamic configuration commands, and menu-driven
configuration commands. Data and dynamic
configuration commands are issued by a host control
module. Menu-driven configuration commands are
issued by a host control module, the service port, or the
service modem.
5.3 BASE UNIT DATA COMMANDS
This section addresses the data commands supported by
the base unit itself. Refer to the appropriate sections
for the host control module and the various I/O modules
for a description of data commands supported by those
M Series components. The various configuration
commands supported by the base unit are described in
Section 6 (Base Unit Configuration).
The base unit supports data commands: Read Time,
Reset and Echo Mode.