Owner`s manual

61
6.1 BASE UNIT FRONT PANEL
CONFIGURATION
NOTE: This section does not apply to units equipped
with LEDs.
The base unit is configured from the front panel by
pressing the SELECT key when the LCD displays "Module
/0/0/0". The base unit main menu will appear as follows:

MAIN MENU 
Set Time 
Set Date 
Set Unit 

You can select the current time and date as well as the
Unit Number from this menu. Highlight the desired
selection with the blinking cursor by pressing the > and
? keys on the front panel and then press SELECT. You
can exit from the base unit main unit by selecting "Exit"
which is not shown in the initial main menu. Use the >
and ? keys to display the "Exit" selection. If you select
"Set Time", the following menu will appear:

SET TIME 
HH:MM:SS 
Up and Dwn to change
Select to accept 

The "SET TIME" menu is used to program the base unit's
time-of-day clock. The first highlighted entry is seconds
(SS). Choose the desired seconds using the > and ?
keys and press SELECT. The next highlighted entry is
minutes (MM). Likewise, use the > and ? keys to select
the desired minutes and press SELECT. The last
highlighted entry is hours (HH). Once the desired time
has been selected, the display will return to the "MAIN
MENU".