Owner`s manual

If you select "Set Date" from the "MAIN MENU", the

following menu will appear:



SET DATE 

MM/DD/YY 

Up and Dwn to change

Select to accept 



The "SET DATE" menu is used to program the base unit's

date. The first highlighted entry is year (YY). Choose

the desired year using the > and ? keys and press

SELECT. The next highlighted entry is day (DD).

Likewise, use the > and ? keys to select the desired

minutes and press SELECT. The last highlighted entry is

month (MM). Once the desired date has been selected,

the display will return to the "MAIN MENU".

NOTE: While in configuration mode, the date is not

updated until the "SET DATE" menu is exited. The date

reported by individual modules may not be updated

immediately. Modules are operating properly if they

update their reporting dates within a minute from the

time the "SET DATE" menu is exited.

If you select "Set Unit" from the "MAIN MENU", the

following menu will appear:



SET UNIT 

XX 

Up and Dwn to change

Select to accept 



The "SET UNIT" menu is used to assign individual M

Series units a Unit Number. The Unit Number is

required to identify an individual unit when it is

installed as a node in a network. The Unit Number is

used by individual I/O modules as part of the

designated host module address where data messages

are sent to in auto reporting mode.