Owner`s manual

6.2 HOST MODULE, SERVICE PORT, AND

SERVICE MODEM CONFIGURATION

To access configuration mode of the base unit from the

V71 host module, use the following procedure. The M-

Series service port and the V71 host module will not

respond to commands for approximately 15 seconds

after the unit is powered up or reset.

1. Connect a terminal to the V71 host module and

configure the terminal's serial parameters to

match those of the host module. From the

factory, the V71 host module is set at 9600 baud

rate, 8 word size, 1 stop bit, and no parity.

2. Connect to the base unit by sending the port

select code ($BT - default), 0, and Carriage Return

or Line Feed.

3. Access configuration mode by sending

$CONFIG<cr> where <cr> is Carriage Return. For

example, if using the default port select code,

send $BT0<cr>$CONFIG<cr> to enter into

configuration mode for the base unit. No

characters should be typed between $BT0<cr> and

$CONFIG<cr>.

To access the configuration mode of the base unit from

the service port or service modem, use the following

procedure:

1. If configuring from the service port, connect a

terminal to the EIA-232 service port and configure