If you have any questions contact the SAS Technical Support Department at: Phone - (225) 272 7135 • Fax - (225) 272-9844 Email - tech@bazooka.com • Website - www.bazooka.com In Canada: (604) 988 2966 15049 Florida Blvd., Baton Rouge, LA. 70819 , SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc. PAT. NO. 4,567,959 • PAT NO.
CONGRATULATIONS Dear Friend, Thank you for selecting Bazooka® subwoofer speaker systems for your car stereo system. The Bazooka Reference series represents SAS‘s continued commitment to efficiency and design. An innovative manufacturing process developed by SAS for the Bazooka provides consumers with state-of-the-art speaker system design.
CONTENTS Phase Alert When one of the Amplified Bazooka's High-level Input channels is out of phase electrically with the other High-level Input channel your Bazooka will sound as if it has little or no output, and any output that is produced may sound distorted. If you suspect that your Bazooka is out of phase, use the AM I IN PHASE procedure to diagnose and correct the Bazookas' output, and proper bass response will be produced.
GROUND WIRE CONT. INSTALLATION The ground point in the car should be a piece of chassis metal that is part of or welded to the main body of the vehicle. Painted surfaces should be scraped or sanded clean to expose the bare metal before the ground lug is bolted down. (Cover the bare metal area with paint or grease after you finish mounting the ground wire to prevent rust.) TRUCK INSTALLATION Figure 1 REMOTE TURN ON OPTIONS The ORANGE wire on the Amplified Bazookas' 14-pin Molex Mini-fit Jr.
INSTALLATION POWER WIRE Please take time to read through this manual and plan out your installation before you begin! The 12 gauge red wire on the 2-pin power plug is the 12 Volt positive power wire. It must be fused and connected directly to the positive terminal of the battery to provide a power source with a low voltage drop and low noise. Do not make the power connection at the fuse block or any point other than the battery. Improper power sources can reduce output and cause distortion.
MOUNTING THE BAZOOKA WIRING DIAGRAM When using high level inputs, take the time after you make all wiring connections to run through the AM I IN PHASE? procedure of this manual to confirm that your inputs are in correct electrical phase and the proper bass response is being produced. 1. With the top side of the buckle facing up (see figure 4), lace the strap through the mounting base as illustrated in figure 5. Figure 4 Bottom Top Figure 5 2.
MOUNTING THE BAZOOKA MOUNTING THE BAZOOKA 3. Place each mounting base under the Bazooka so that the apex at the bottom of the tube sits inside the mounting base as in figure 7. See Model Size For Length Figure 9 4. Move the bases so that they are spaced approximately 3” from each end of the enclosure as illustrated in figure 8. Figure 7 Model Length RS6A RS8A RS10A 17” 22” 27” 8. Remove any slack in the strap by feeding it out of the mounting base on the loose end of the strap opposite the buckle.
MOUNTING THE BAZOOKA MOUNTING THE BAZOOKA 3. Place each mounting base under the Bazooka so that the apex at the bottom of the tube sits inside the mounting base as in figure 7. See Model Size For Length Figure 9 4. Move the bases so that they are spaced approximately 3” from each end of the enclosure as illustrated in figure 8. Figure 7 Model Length RS6A RS8A RS10A 17” 22” 27” 8. Remove any slack in the strap by feeding it out of the mounting base on the loose end of the strap opposite the buckle.
MOUNTING THE BAZOOKA WIRING DIAGRAM When using high level inputs, take the time after you make all wiring connections to run through the AM I IN PHASE? procedure of this manual to confirm that your inputs are in correct electrical phase and the proper bass response is being produced. 1. With the top side of the buckle facing up (see figure 4), lace the strap through the mounting base as illustrated in figure 5. Figure 4 Bottom Top Figure 5 2.
INSTALLATION POWER WIRE Please take time to read through this manual and plan out your installation before you begin! The 12 gauge red wire on the 2-pin power plug is the 12 Volt positive power wire. It must be fused and connected directly to the positive terminal of the battery to provide a power source with a low voltage drop and low noise. Do not make the power connection at the fuse block or any point other than the battery. Improper power sources can reduce output and cause distortion.
GROUND WIRE CONT. INSTALLATION The ground point in the car should be a piece of chassis metal that is part of or welded to the main body of the vehicle. Painted surfaces should be scraped or sanded clean to expose the bare metal before the ground lug is bolted down. (Cover the bare metal area with paint or grease after you finish mounting the ground wire to prevent rust.) TRUCK INSTALLATION Figure 1 REMOTE TURN ON OPTIONS The ORANGE wire on the Amplified Bazookas' 14-pin Molex Mini-fit Jr.
CONTENTS Phase Alert When one of the Amplified Bazooka's High-level Input channels is out of phase electrically with the other High-level Input channel your Bazooka will sound as if it has little or no output, and any output that is produced may sound distorted. If you suspect that your Bazooka is out of phase, use the AM I IN PHASE procedure to diagnose and correct the Bazookas' output, and proper bass response will be produced.
CONGRATULATIONS Dear Friend, Thank you for selecting Bazooka® subwoofer speaker systems for your car stereo system. The Bazooka Reference series represents SAS‘s continued commitment to efficiency and design. An innovative manufacturing process developed by SAS for the Bazooka provides consumers with state-of-the-art speaker system design.
If you have any questions contact the SAS Technical Support Department at: Phone - (225) 272 7135 • Fax - (225) 272-9844 Email - tech@bazooka.com • Website - www.bazooka.com In Canada: (604) 988 2966 15049 Florida Blvd., Baton Rouge, LA. 70819 , SAS, BAZOOKA, BASS TUBES, and LISTEN TO YOUR EARS are registered trademarks of Southern Audio Services, Inc. PAT. NO. 4,567,959 • PAT NO.